SIIG 2-Port Serial 550-Value Guía de instalación

1SIIG 2-Port Serial 550-ValueQuick Installation Guide04-0352BIntroducing the SIIG 2-Port Serial 550-ValueThe SIIG 2-Port Serial 550-Value provides two

10Blank Page

11Technical Support and WarrantyQUESTIONS? SIIG’s Online Support has answers! Simply visit ourweb site at www.siig.com and click Support. Our onlin

SIIG 2-Port Serial 550-Value is a trademark of SIIG, Inc. SIIG and the SIIG logo are registeredtrademarks of SIIG, Inc. Microsoft, Windows and Windo

2LayoutFigure 1. Board Layout*Note: Do not move the jumpers from the defaultsettings. This board is designed to work at 115K.Hardware InstallationG

34. Carefully align the card to the selected PCI slot,push the board down firmly, but gently, until it iswell seated.5. Replace the slot bracket screw

4Windows ME1. At the Add New Hardware Wizard, check Specifythe location of the driver (Advanced), then clickNext.2. Check Specify a location, uncheck

5Windows XP1. At the Found New Hardware Wizard,For XP SP2 or later: Select No, not this time, clickNext. Select Install from a list or specific loca

6Windows Server 20031. At the Found New Hardware Wizard,For Server 2003 SP1 or later: Select No, not this time,click Next. Select Install from a li

7Windows Vista ™1. At the Found New Hardware window, click Locateand install driver software (recommended), clickContinue.2. When prompted, insert the

8Windows NT 4.01. Click Start, Settings, Control Panel.2. Click Serial Port tab, two serial ports should belisted under Ports.Windows 2000/XP (32-bit

9Blank Page