SIIG 4-Port Serial PCI Card Guía de instalación descargar pdf (Pagina 3)

Hardware Installation

General instructions for installing the card are provided

below. Refer to your computer’s reference manual for

further information, if needed.

Static Electricity Discharge may permanently damage

your system. Discharge any static electricity build up in

your body by touching your computer’s case for a few

seconds. Avoid any contact with internal parts and

handle cards only by their external edges.

1. Turn OFF the power to your computer and any

other connected peripheral devices.

2. Unplug the power cord from the computer.

3. Remove your computer’s cover.

4. Remove the slot bracket from an available PCI slot.

5. Change JP1-JP4 jumper settings to the desired

voltage only if your serial device(s) needs additional

power from the serial port. For more information go

to Figure 1 on page 2. Skip this step if power is not

required.

6. To install the card, carefully align the card's bus

connector with the selected PCI slot on the

motherboard. Push the board down firmly, but

gently, until it is well seated.

7. Replace the slot bracket's holding screw to secure

the card.

8. Replace the computer cover and reconnect the power

cord.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

SIIG 4-Port Serial PCI Card Guía de instalación Pagina 3