SIIG Cyber 1S1P PCI Guía de instalación descargar pdf (Pagina 4)

5. Set JP1 jumper settings to the desired voltage only

if your serial device needs additional power from

the serial port. For more information, see Jumper

Setting on page 2. Skip this step if power is not

required.

6. Carefully align the card's bus connector with the

selected PCI slot on the motherboard. Push the

board down firmly, but gently, until it is well seated.

Replace the slot bracket holding screw to secure the

card.

7. Connect the system power supply to board's 4-pin

power connector. This connection is optional, see

Figure 1 on page 2 for more information.

8. Replace the computer cover and reconnect the power

cord.

9. Connect the Fan-out cable to the board's 44-pin

connector. Hardware installation is now complete.

Software Installation

This section provides information on how to install the

CyberPro 1S1P drivers.

Windows 95

1. At the Update Device Driver Wizard, click Next.

2. Insert the driver CD, then click Other Locations,

type D:\9x, click OK, then click Finish.

(Change D: to match your CD-ROM drive letter)

3. At the Insert Disk window, click OK. When the

Copying Files dialog box appears, type in

D:\9x, then click OK.

4. Repeat steps 1-3.

5. Restart Windows to complete the installation.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

SIIG Cyber 1S1P PCI Guía de instalación Pagina 4