SIIG CyberParallel Dual PCIe Guía de instalación descargar pdf (Pagina 3)

3. Remove your computer’s cover.

4. Remove the slot bracket from an available PCI

Express slot.

5. Connect the DB25 ribbon cable to Parallel port 2.

Make sure the stripe on the cable faces Pin-1 on the

connector. See Layout on page 2 for more

information. Skip this step, if the second parallel

port is not needed.

6. To install the card, carefully align the card's bus

connector with the selected PCI Express slot on the

motherboard. Push the board down firmly, but

gently, until it is well seated.

7. Replace the slot bracket holding screw to secure the

card.

8. Replace the computer cover and reconnect the power

cord.

Driver Installation

This section provides information on how to install the

CyberParallel Dual PCIe drivers.

Windows 2000

1. At the Found New Hardware Wizard, click Next.

2. Select Search for a suitable driver for my device

(recommended), then click Next.

3. Check Specify a location, uncheck the other options

and click Next.

4. Insert the driver CD, type in D:\2000, then click OK.

(Change D: to match your CD-ROM drive letter)

5. Click Next, then click Finish.

6. Restart Windows to complete the installation.

1 2 3 4 5 6 7 8

Sin comentarios

SIIG CyberParallel Dual PCIe Guía de instalación Pagina 3