SIIG JJ-E20011-S1 Guía de instalación descargar pdf (Pagina 4)

4. Set J1 and J2 jumper settings to the desired voltage

only if your serial device needs additional power

from the serial port. However, most serial devices

do not require additional power. If power output is

required, connect the board's power connector to

the system power supply. For more information see

Jumper Settings on page 2.

5. To install the card, carefully align the card's bus

connector with the selected PCI Express slot on the

motherboard. Push the board down firmly, but

gently, until it is well seated.

7. Replace the slot bracket screw to secure the card.

8. Replace the computer cover and reconnect the power

cord.

9. Connect the Mini 2-port fan-out cable to the fan-out

cable connector on the card.

Driver Installation

This section provides information on how to install the

CyberSerial Dual PCIe drivers.

Windows 7 (32-/64-bit)

1. Right click Computer, click Manage, click Device

Manager. Insert the driver CD.

Note: Close the CD AutoPlay box if prompted.

2. Right click PCI Device, click Update Driver

Software.

3. Click Browse my computer for driver software.

4. Type D:, then click Next. (Change D: to match your

CD/DVD-ROM drive letter)

5. At Windows has successfully updated your driver

software, click Close.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

SIIG JJ-E20011-S1 Guía de instalación Pagina 4