SIIG Low Profile USB 2.0 Guía de instalación descargar pdf (Pagina 3)

Driver Installation

The Low Profile USB 2.0 adapter has three built-in USB

hosts. Two hosts handle USB 1.1 devices and the third

host handles USB 2.0 devices. USB 1.1 and USB 2.0

devices are automatically routed to the correct USB hosts.

Windows 98SE

1. Install the board and boot up your system. At the

Add New Hardware Wizard, click Cancel three

times.

2. Insert the driver diskette. Click Start, Run, type in

A:\setup.exe, then click OK.

3. Choose Yes, I want to restart my computer now,

click Close to restart Windows, and remove the

driver diskette.

4. When Windows restarts, a USB 1.1 host is detected.

5. At the Add New Hardware Wizard, click Next.

6. Choose Search for the best driver for your device.

(Recommended)., click Next.

7. Clear all check boxes, click Next, and Next again.

8. Click Next, then Finish.

Note: If prompted for the Windows Installation

CD-ROM, click OK. Insert this CD and click OK.

9. Repeat steps 5-8 one more time when the second

USB 1.1 host is detected.

10. Windows now detects the USB 2.0 host and loads it's

driver.

11. The board is now ready for use.

1 2 3 4 5 6 7 8

Sin comentarios

SIIG Low Profile USB 2.0 Guía de instalación Pagina 3