SIIG SATA II PCIe RAID Guía de instalación descargar pdf (Pagina 11)

Software Installation

This section provides information on how to install the

SATA II PCIe RAID drivers.

Table of Contents

Windows 2000 ........................................... page 11-12

Windows XP/Server2003 ........................ page 12-13

Verify Windows Installation ........................ page 14

Windows 2000

For A New Installation

A new installation of Windows 2000 requires a floppy

disk for the driver installation. To make this floppy disk,

copy the contents of the Floppy folder, found on the

driver CD, onto a blank floppy disk then follow the

directions below.

1. Setup the RAID array prior to Windows installation.

2. Follow Windows 2000 installation procedure.

3. Restart the computer when prompted by the

installation.

4. At the Windows 2000 Setup screen, press F6 to

install the RAID driver.

5. When prompted, press S to specify the location of

the driver.

6. Insert the floppy disk, then press Enter.

7. Select Silicon Image Sil 3132 SoftRaid 5 Controller

for Windows 2000, then press Enter.

8. Press Enter again to finish driver installation, then

follow the on-screen instructions to complete the

Windows installation.

When Windows installation completes, go to SATARaid5

GUI on page 14 and install the RAID utility.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sin comentarios

SIIG SATA II PCIe RAID Guía de instalación Pagina 11