SIIG Serial ATA 4-Channel RAID Guía de instalación descargar pdf (Pagina 8)

2. At the next screen select Create RAID Set, then

press Enter.

3. At the next screen select RAID1 then press Enter.

4. Select Manual configuration, then press Enter.

5. Select the Source drive, press Enter.

6. Select the Target drive, press Enter.

7. Select Create with data copy, then press Enter.

8. Select online copy, then press Enter.

Note: Selecting Online Copy builds the mirror

while in Windows. Selecting Offline Copy builds

the mirror before exiting the RAID bios.

9. When asked Are You Sure (Y/N)?, press Y.

10. Press Ctrl+E to exit the BIOS.

11. When asked Are you sure to exit (Y/N)?, press Y to

exit.

Note: If during restart the RAID BIOS reports an

incomplete Mirror set, disregard the message,

continue booting, and let the Mirror rebuild.

Creating a SPARE Drive

When a hard drive failure occurs in a mirror set, the auto-

rebuild feature enables a drive designated as SPARE to

become the new member of the mirror set.

1. During boot press Ctrl+S or F4 to enter the RAID

BIOS.

2. Select Create RAID Set press Enter.

3. Select SPARE DRIVE, then press Enter.

4. Select the single hard drive then press Enter.

5. When asked Are You Sure (Y/N)?, press Y to confirm.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

Sin comentarios

SIIG Serial ATA 4-Channel RAID Guía de instalación Pagina 8