SIIG DP CyberSerial 2S PCI Guía de instalación descargar pdf (Pagina 4)

5. Set JP1 and JP2 jumper settings to the desired voltage

only if your serial device needs additional power

from the serial port. However, most serial devices

do not require additional power. For more

information see Figure 1 on page 2. The jumpers

can be removed if power is not required.

6. To install the card, carefully align the card's bus

connector with the selected PCI slot on the

motherboard. Push the board down firmly, but

gently, until it is well seated.

7. Replace the slot bracket holding screw to secure the

card.

8. Replace the computer cover and reconnect the power

cord.

9. Connect the 2-port fan-out cable to the board's

25-pin connector. See Figure 2 on page 3 for more

details.

Driver Installation

Make sure the board is installed into the computer before

proceeding.

Windows 8 (32-/64-bit) / 7 (32-/64-bit) / Server

2008 R2

1. Insert the driver CD. Close the CD autoplay box if

prompted.

2. Right click Computer, click Manage, click Device

Manager.

3. Right click PCI Serial Port under Other devices,

click Update Driver Software, then click Browse

my computer for driver software.

4. Type D:, then click Next. (Change D: to match your

CD/DVD-ROM drive letter)

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

SIIG DP CyberSerial 2S PCI Guía de instalación Pagina 4