SIIG JJ-000082-S1 Guía de instalación descargar pdf (Pagina 8)

Note: When installing the ExpressCard Bay into a

5.25" drive bay, install it into the supplied 5.25"

mounting rack before mounting into the drive bay

and follow the same assembly instructions. Refer

to 5.25" Mounting Rack Assembly on page 3.

9. Connect the other end of the USB cable to the

system's internal USB Pin-out Header, see

Motherboard USB Pin-out Header on page 6 for

more information. Match up +5VDC (Pin 1) on the

USB cable connector to Pin 1 or Pin 2 on the

motherboard's USB pin-out header. Caution:

Connecting the cable improperly may damage your

system. Refer to your system's manual for proper

connection.

10. Boot-up Windows and the PCIe to ExpressCard Bay

is ready for use. No driver installation is needed.

Inserting/Removing ExpressCard

PCI Express-based ExpressCard Devices

PCI Express-based ExpressCard devices are not

hot-plug/hot-swap compatible through this adapter.

Insert a PCI Express-based ExpressCard before startup

or restart the computer after inserting the card.

• To insert, position the ExpressCard on the left

hand side of the ExpressCard slot, then gently

slide the ExpressCard into the slot until the locking

mechanism clicks then release pressure.

• To remove the ExpressCard, gently press in on the

ExpressCard to unlock, then pull it out.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

SIIG JJ-000082-S1 Guía de instalación Pagina 8