SIIG SC-UNS012 Guía de instalación descargar pdf (Pagina 3)

Package Contents

• (1) USB 2.0+FireWire+SATA Combo board

• (1) Serial ATA cable

• (1) Serial ATA 15-pin power cable adapter

• (1) USB 2.0 driver diskette

• (1) Serial ATA driver diskette

• This quick installation guide

Hardware Installation

General instructions for installing the card are provided below,

since the design of computer cases and motherboards vary. Refer to

your computer’s reference manual for further information, if needed.

Static Electricity Discharge may permanently damage your system.

Discharge any static electricity build up in your body by touching

your computer’s case for a few seconds. Avoid any contact with

internal parts and handle cards only by their external edges.

• Turn OFF the power to your computer and any other

connected peripheral devices. Unplug the computer's power

cord.

• Remove your computer’s cover and install the card in an

available PCI slot.

• Push the board down firmly, but gently, until it is well seated.

• Secure the card and replace the cover.

Figure 2. Inserting the PCI Board

1 2 3 4 5 6 7 8 9 10

Sin comentarios

SIIG SC-UNS012 Guía de instalación Pagina 3