SIIG SC-UNS012 Guía de instalación descargar pdf (Pagina 7)

1. Boot up Windows. At the Found New Hardware Wizard

window, click Cancel two times.

2. Insert the USB 2.0 driver diskette. Click Start, Run, type in

A:\setup206.exe, then click OK.

3. Click Continue Anyway. Our driver has been thoroughly tested

in Windows for stability. This message appears because Microsoft

has not tested this product through WHQL certification.

4. Choose Yes, I want to restart my computer now, then click

Close. Remove the driver diskette.

5. Insert the Serial ATA driver diskette after Windows resumes.

6. At the Found New Hardware Wizard window, choose Install

the software automatically (Recommended), then click Next.

7. Click Continue Anyway and Finish.

8. Repeat steps 6-7 two more times to complete driver

installation.

To verify successful driver installation:

1. Check Device Manager to verify successful driver installation.

Windows 98SE/ME: From the main desktop, right click My

Computer, click Properties, then click Device Manager.

Windows 2000/XP: Right click My Computer, click Manage,

then click Device Manager.

2. Double click Universal Serial Bus controllers and the

following options should be displayed, in addition to others

that may come with your system.

- NEC PCI to USB Enhanced Host Controller

- NEC PCI to USB Open Host Controller...

- USB 2.0 Root Hub Device

- USB Root Hub

Note: With XP Service Pack 1 installed, the USB entries

are different from what is listed above but function

normally.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

SIIG SC-UNS012 Guía de instalación Pagina 7