SIIG UltraATA 133 PCI RAID Guía de instalación descargar pdf (Pagina 18)

5. If the Digital Signature Not Found message appears,

click Yes. Our driver has been thoroughly tested in

Windows for stability.

Note: If prompted for Windows 2000 CD-ROM,

insert the CD into your CD-ROM drive and click

OK. Type in D:\I386 (change D: to match your

CD-ROM drive letter), click OK, then Finish.

6. Click Finish, remove the driver CD, then restart

Windows to complete driver the installation.

When Windows resumes, go to Medley GUI on page 22

and install the RAID monitoring utility.

32- bit Windows XP/Server 2003

For A New 32-bit Windows XP /Server 2003 Installation

A new installation of Windows XP/Server 2003 requires

a floppy disk for the driver installation. To make this

floppy disk, copy the contents of the 32bit folder, found

on the driver CD, onto a blank floppy disk then follow the

directions below.

1. Setup the RAID array prior to Windows installation.

2. Follow Microsoft's Windows installation procedure.

3. Restart the computer when prompted by Windows'

installation.

4. At the Windows Setup screen, when prompted,

press F6 to install the driver.

5. When prompted press S to specify the location of

the driver.

6. Insert the driver diskette, then press Enter.

7. Silicon Image Ultra-133 Medley ATA RAID

Controller will appear in the box, press Enter.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Sin comentarios

SIIG UltraATA 133 PCI RAID Guía de instalación Pagina 18