SIIG USB Over IP Guía de instalación descargar pdf (Pagina 6)

Windows XP (32-/64-bit)

1. Connect the USB over IP to your network.

2. At the Windows desktop insert the driver CD.

3. Autorun should start the installation, if not, click

Start, then Run. Type D:\Launch.exe then click

OK. (Change D: to match your CD-ROM drive

letter)

4. At the USB Over IP screen click Install.

5. At Choose Components, click Next.

6. At Choose Install Location, click Install.

7. At the Security Alert, click Yes. (skip this step for XP

32-bit)

8. Click Yes to add the application to Windows Firewall

exceptions list, then click Finish.

9. At the Found New Hardware Wizard, select No, not

this time, click Next. (skip this step if not prompted)

10. Select Install the software automatically

(Recommended), click Next.

11. At the Security Alert, click Yes. (skip this step for XP

32-bit)

12. Click Finish.

13. At Windows Security Alert, click Unblock. (skip

this step if you clicked Yes to add this application to

firewall exceptions list on step 8)

14. Repeat steps 9-12 for each USB over IP connected

that matches your subnet address.

15. Close the USB Over IP screen to complete the

installation.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Sin comentarios

SIIG USB Over IP Guía de instalación Pagina 6