SIIG I/O Expander 2S Manual de usuario descargar pdf (Pagina 12)

3-12

I/O Expander 4S User's Manual

6. To install the connector bracket, carefully slide it into

the selected rear panel slot where the slot cover had

been removed. Replace the holding screw to secure

the connector bracket in place.

7. Connect the 10-pin connector on the end of each serial

port’s attached ribbon cable to the

SIO3SIO3

SIO3 and

SIO4SIO4

SIO4 10-pin

connectors on the I/O Expander 4S board. It does not

matter which connector on the board they are attached

to. However, make a note as to connections so you will

know each port’s COM address and IRQ.

Figure 3-4: Installing the Connector BracketFigure 3-4: Installing the Connector Bracket

Figure 3-4: Installing the Connector Bracket

S104

S103

Note: Please match

the colored wire

edge with pin 1.

SIO4

SIO3

1 2 ... 7 8 9 10 11 12 13

Sin comentarios

SIIG I/O Expander 2S Manual de usuario Pagina 12