SIIG I/O Expander 2S Manual de usuario descargar pdf (Pagina 7)

3-7

Hardware Installation

WARNING: Disconnect the AC power sourceWARNING: Disconnect the AC power source

WARNING: Disconnect the AC power source

before removing the cover.before removing the cover.

before removing the cover.

2. Unplug all power cords and cables from the back of the

computer. (Be sure to note the cable connections for

reconnection when the installation is complete.)

3. Remove your computer’s cover by removing its mounting

screws with a screwdriver. Slide the cover OFF.

4. Your I/O Expander 4S card must be installed in an

available 16-bit expansion slot.

5. Remove the selected expansion slot cover by unscrewing

the holding screw and sliding the cover out. Save this

screw for securing the I/O Expander 4S card after it’s

installed.

6. To install the I/O Expander 4S card, carefully align the

card’s bus connector with the selected bus slot on the

motherboard. Push the card down firmly, but gently,

until it is well seated.

Figure 3-1: Remove the Slot CoverFigure 3-1: Remove the Slot Cover

Figure 3-1: Remove the Slot Cover

1 2 3 4 5 6 7 8 9 10 11 12 13

Sin comentarios

SIIG I/O Expander 2S Manual de usuario Pagina 7