SIIG SATA II PCIe RAID Guía de instalación descargar pdf (Pagina 14)

Windows Vista

For A New Installation

1. Setup the RAID array prior to Windows installation.

2. Follow Windows installation procedure.

3. At Where do you want to install Windows?, click

Load Driver.

4. Remove the Windows installation disk, and insert

the driver CD.

5. Click Browse, double click your CD-ROM drive:

For 32-bit Windows: Select 32bit folder, then click OK.

For 64-bit Windows: Select 64bit folder, then click OK.

6. Check Hide drivers that are not compatible with

hardware on this computer, select Silicon Image

SiI 3132 SoftRaid5 Controller..., then click Next.

7. Wait while Windows configures the drivers. When

the progress bar ends, re-insert the Windows

installation disk, click Refresh.

8. Follow the on-screen instructions to complete your

Windows installation.

When Windows installation completes, go to SATARaid5

GUI on page 18 and install the RAID utility.

For An Existing Installation

1. Setup the RAID array prior to driver installation and

boot up to Windows.

2. At the Found New Hardware window, click Locate

and install the driver automatically (recommended).

3. Insert the driver CD, click Continue.

4. Click Next, then Close to complete the installation.

When Windows resumes, go to SATARaid5 GUI on

page 18 and install the RAID utility.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Sin comentarios

SIIG SATA II PCIe RAID Guía de instalación Pagina 14