SIIG SATA II PCIe RAID Guía de instalación descargar pdf (Pagina 16)

For An Existing Installation

1. Setup the RAID array prior to driver installation and

boot up to Windows.

2. At the Found New Hardware Wizard, select No, not

this time, then click Next. (Skip this step if not

prompted)

3. Insert the driver CD, select Install the software

automatically (Recommended), and click Next.

4. Click Finish to complete the driver installation.

When Windows resumes, go to SATARaid5 GUI on

page 18 and install the RAID utility.

Windows XP / Server 2003 (64-bit )

For A New Installation

A new installation requires a floppy disk for the driver

installation. To make this floppy disk, copy the contents

of the 64bit folder, found on the driver CD, onto a blank

floppy disk then follow the directions below.

1. Setup the RAID array prior to Windows installation.

2. Follow Windows installation procedure.

3. Restart the computer when prompted by Windows'

installation.

4. At the Windows Setup screen, press F6 to install the

RAID driver.

5. When prompted, press S to specify the location of

the driver.

6. Insert the floppy disk, then press Enter. Do not

remove the floppy disk until prompted.

7. Select Silicon Image Sil 3132 SoftRaid 5 Controller

(64-bit Extended), then press Enter.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Sin comentarios

SIIG SATA II PCIe RAID Guía de instalación Pagina 16