SIIG SATA II PCIe RAID Guía de instalación descargar pdf (Pagina 15)

To Verify Windows Vista Installation

1. Right click Computer, click Manage, click Continue,

select Device Manager.

2. Double click Storage controllers, then double click

Silicon Image Sil 3132 SoftRaid 5 Controller to

display driver properties. When This device is working

properly is displayed in the dialog box, the driver

has been correctly installed.

Windows XP / Server 2003 (32-bit)

For A New Installation

A new installation requires a floppy disk for the driver

installation. To make this floppy disk, copy the contents

of the 32bit folder, found on the driver CD, onto a blank

floppy disk then follow the directions.

1. Setup the RAID array prior to Windows installation.

2. Follow Windows installation procedure.

3. At the Windows Setup screen, press F6 to install the

RAID driver.

4. When prompted, press S to specify the location of

the driver.

5. Insert the floppy disk, then press Enter. Do not

remove the floppy disk until prompted.

6. Select Silicon Image SiI 3132 SoftRaid 5 Controller

for Windows XP/Server 2003, then press Enter.

7. Press Enter again to finish the driver installation,

then follow the on-screen instructions to complete

your Windows installation.

When Windows installation completes, go to SATARaid5

GUI on page 18 and install the RAID utility.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Sin comentarios

SIIG SATA II PCIe RAID Guía de instalación Pagina 15