SIIG Serial ATA PCI Guía de instalación descargar pdf (Pagina 13)

4. Click Next, then click Finish.

5. Remove the driver CD, shutdown Windows, and

setup your RAID array.

When Windows resumes, go to Installing SATARaid

GUI on page 20 and install the RAID utility.

Windows XP (64-bit) / Server 2003 (64-bit)

For a New Windows XP / Server 2003 Installation

A new installation requires a floppy disk for the driver

installation. To make this floppy disk, copy the contents

of the 64bit folder, found on the driver CD, onto a blank

floppy disk then follow the directions below.

1. Setup the RAID array prior to Windows installation.

2. Follow Microsoft procedure to install Windows.

3. Restart your system when prompted during

Windows' installation.

4. At the Windows Setup screen, press F6 to continue.

5. Insert the driver diskette. Press S then press Enter

6. Select Silicon Image SiI... Controller (64-bit

Extended) and press Enter.

7. Press Enter to continue and follow on-screen

instructions to complete the installation.

When Windows installation completes, go to Installing

SATARaid GUI on page 20 and install the RAID utility.

For an Existing Windows XP / Server 2003 Installation

1. Install the board and boot up Windows.

2. At the Found New Hardware Wizard:

For XP (w/SP1 or earlier)/Server 2003: Go to step #3.

For XP (w/SP2 or later)/Server 2003 (w/ SP1 or later):

Select No, not this time, then click Next.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Sin comentarios

SIIG Serial ATA PCI Guía de instalación Pagina 13