SIIG Serial ATA PCI Guía de instalación descargar pdf (Pagina 19)

Windows 98SE

For a New Windows 98SE Installation

1. Setup the RAID array prior to Windows installation.

2. Follow Microsoft Windows installation procedure.

3. Once Windows has installed, right click My

Computer, click Properties, click Device Manager.

4. Double click PCI RAID controller listed under

Other Devices.

5. Select Driver tab, then click Update Driver button.

6. Insert the driver CD, then click Next.

7. Select Search for the better driver ... and click Next.

8. Check CD-ROM drive, uncheck the other boxes,

then click Next. Click Next again, then Finish.

9. Remove the driver CD, then restart Windows to

complete the installation.

When Windows installation completes, go to Installing

SATARaid GUI on page 20 and install the RAID utility.M

For an Existing Windows 98SE Installation

1. Install the board and boot up to Windows.

2. At the Add New Hardware Wizard, click Next to

continue.

3. Select Search for the best driver for your device

option then click Next.

4. Insert the driver CD, check CD-ROM drive, uncheck

the other check boxes, then click Next.

5. Click Next, then Finish.

6. Remove the driver CD, shutdown Windows, and

setup your RAID array.

When Windows resumes, go to Installing SATARaid

GUI on page 20 and install the RAID utility.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Sin comentarios

SIIG Serial ATA PCI Guía de instalación Pagina 19