SIIG UltraATA 133 PCI Guía de instalación descargar pdf (Pagina 11)

3. Select Set RAID Mode, press Enter.

4. Select Mirror * Stripe, then press Enter.

5. Select stripe size then press Enter.

6. Press Y to save your settings.

7. Press Y to erase disk. (Recommended for RAID 0).

8. Select disk drive, press Enter, press Y to erase selected disk.

9. When complete press Enter then ESC to exit and reboot.

10. Continue with conventional Fdisk and Format steps as if you

are installing a conventional hard drive.

11. Your RAID configuration is complete. Please proceed to

Software Installation section.

Note: Do not erase the hard drive (source) you want

mirrored.

Normal Mode (NON-RAID)

The UltraATA 133 PCI RAID will act as a conventional controller

when not configured for RAID. No BIOS configuration is needed.

Please proceed to Software Installation section.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

SIIG UltraATA 133 PCI Guía de instalación Pagina 11