SIIG UltraATA 133 PCI Guía de instalación descargar pdf (Pagina 16)

3. Insert the Driver diskette. Press S then press Enter.

4. Select SIIG CN2496 ATA 133 RAID WinXP Miniport Driver

and press Enter.

5. Press Enter to continue and follow on-screen instructions to

complete Windows XP installation.

Note: When the Software Installation warning pops up, click

Yes. And when the Hardware Installation warning pops up,

click Yes again.

For Existing Windows XP Systems

1. After the UltraATA 133 PCI RAID and attached drives are

configured, boot up Windows.

2. At the Found New Hardware Wizard, check Install from a

list or specific location(advanced), then click Next.

3. Insert the Driver diskette. Check Include this location in the

search, uncheck the other box, type in A:\winXP, and click

Next.

4. When a warning message pops up, click Continue Anyway,

then click Finish.

5. Repeat steps 2-4.

6. Remove the Driver diskette and click Yes to restart Windows.

Verify Proper Installation for Windows 2000/XP

1. Double click My Computer/Control Panel/System.

2. Click Hardware then click Device Manager.

3. Double click SCSI and RAID Controllers, then double click

SIIG CN2496 ATA 133 RAID Controller to display driver

properties.

4. A message This device is working properly is displayed in the

dialog box, the driver has been correctly installed.

RAID Monitoring Utility Installation

1. At the Windows desktop, click Start then Run.

2. Insert the Driver diskette. Type in A:\utility\setup.exe, then

click OK.

3. Follow the onscreen instructions to install the utility.

4. Restart Windows to complete the installation.

1 2 ... 11 12 13 14 15 16 17 18

Sin comentarios

SIIG UltraATA 133 PCI Guía de instalación Pagina 16