SIIG UltraATA 133 PCI Guía de instalación descargar pdf (Pagina 14)

3. Highlight SIIG CN2496 PCI Ultra ATA 133 RAID Adapter

and click Properties. A message This device is working properly

is displayed in the dialog box, the driver has been correctly

installed. If any error message is displayed, remove SIIG

CN2496 PCI Ultra ATA 133 RAID Adapter and restart your

system.

Windows NT 4.0 Driver Installation

For New Windows NT 4.0 System

1. After the UltraATA 133 PCI RAID and attached drives are

configured, follow Microsoft procedures to install Windows

accordingly.

2. At the Windows Set-up screen, press F6 to specify and add

the driver.

3. Press S, select Other, then press Enter.

4. Insert the Driver diskette and press Enter.

5. Select SIIG CN2496 ATA133 RAID NT Miniport Driver and

press Enter.

6. Press Enter to continue and follow on-screen instructions to

complete Windows NT 4.0 installation.

For Existing Windows NT 4.0 System

1. After the UltraATA 133 PCI RAID and attached drives are

configured, boot up Windows. Double click My Computer/

Control Panel/SCSI Adapters, then click the Drivers tab.

2. Click Add… then Have Disk....

3. Insert the Driver diskette into the floppy drive and type in

A:\Winnt, then click OK.

4. Highlight SIIG CN2496 PCI Ultra ATA 133 RAID Controller

and click OK.

5. Remove the Driver diskette and click Yes to restart Windows.

Verify Proper Installation for Windows NT 4.0

1. Double click My Computer/Control Panel/SCSI Adapters.

2. Highlight SIIG CN2496 PCI Ultra ATA 133 RAID Controller

and click Properties. This device is working properly is

displayed in the dialog box, the driver has been correctly

installed.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Sin comentarios

SIIG UltraATA 133 PCI Guía de instalación Pagina 14