SIIG Serial ATA PCI Guía de instalación

1Serial ATA PCIQuick Installation Guide04-0265GIntroducing the Serial ATA PCIThe Serial ATA PCI is an ultra high-speed dual channelSerial ATA controll

10For Existing XP (64-bit) / 2003 (64-bit) Installation1. Install the board and boot up Windows.2. At the Found New Hardware Wizard, select No, notat

113. Select Search for a suitable driver for my device(recommended) and click Next.4. Insert the driver CD, check CD-ROM drives, uncheckthe other boxe

123. Insert the driver CD. The driver will installautomatically.4. Click Close.5. Remove the driver CD and restart your Windows tocomplete the instal

13Verify Server 2008 Installation1. Right click Computer, click Manage, double clickDiagnostics, click Device Manager.2. Double click Storage controll

144. Insert the driver CD, type D:\NT4, then click OK.(Change D: to match the drive letter of yourCD-ROM)5. Highlight Silicon Image in the left colu

157. Click Next, then click Finish. Remove the driver CDand restart Windows to complete the installation.For Existing Windows ME Installation1. Insta

169. Remove the driver CD and restart Windows tocomplete the installation.For Existing Windows 98SE Installation1. Install the board and boot up Wind

17Blank Page

18Blank Page

19Technical Support and WarrantyQUESTIONS? SIIG’s Online Support has answers! Simply visit ourweb site at www.siig.com and click Support. Our onlin

2Package Contents• Serial ATA PCI adapter• Serial ATA cable• Serial ATA power cable• Driver CD• Quick installation guideBoard LayoutFigure 1. Serial

Serial ATA PCI is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG,Inc. Microsoft and Windows are registered trade

31. Turn OFF the power to your computer and anyother connected peripheral devices.2. Unplug the power cord from the back of thecomputer.3. Remove the

4Figure 3. Connecting the Serial ATA cable5. Follow the same instructions when connecting asecond hard drive. Device connection is nowcomplete.6. Re

56. At Where do you want to install Windows?, re-insert the Windows Installation disk, wait severalseconds, then follow the on-screen instructions toc

6For Itanium processors: Select IA64, then click OK5. Click Next.6. At Where do you want to install Windows?, re-insert the Windows Installation disk,

73. Insert the driver CD, then click OK.4. Select Silicon Image SiI... SATALink Controller...,then click Next.5. Follow the on-screen instructions to

82. At the Found New Hardware Wizard, select Locateand install driver software (recommended), clickContinue. Click Don't search online.3. Insert

9For Existing Windows XP / Server 2003 Installation1. Install the board and boot up Windows.2. At the Found New Hardware Wizard:XP (w/SP1 or earlier)