SIIG Serial ATA PCI Guía de instalación descargar pdf (Pagina 9)

For Existing Windows XP / Server 2003 Installation

1. Install the board and boot up Windows.

2. At the Found New Hardware Wizard:

XP (w/SP1 or earlier) / Server 2003: Continue to

step #3

XP (w/SP2 or later) / Server 2003 (w/ SP1 or later):

Select No, not at this time, then click Next.

3. Insert the driver CD, select Install the software

automatically (Recommended), and click Next.

4. Click Finish and restart Windows to complete the

installation.

Windows XP (64-bit) / Server 2003 (64-bit)

For New XP (64-bit) / 2003 (64-bit) Installation

A new installation of Windows XP (64-bit) / Server 2003

(64-bit) requires a floppy disk for the driver installation.

To make this floppy disk, copy the contents of the 64bit

folder, found on the driver CD, onto a blank floppy disk

then follow the directions below.

1. Install the board and follow Microsoft procedures

to install Windows accordingly.

2. Restart your system when prompted by Windows

installation.

3. At the Windows Setup screen, press F6 to install the

driver.

4. Insert the floppy disk you made above. Press S then

press Enter.

5. Select Silicon Image SiI 3512... that matches your

system processor, then press Enter.

6. Press Enter to continue and follow the on-screen

instructions to complete the installation.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

SIIG Serial ATA PCI Guía de instalación Pagina 9