SIIG Serial ATA PCI Guía de instalación descargar pdf (Pagina 12)

Windows NT 4.0

A new installation of Windows NT requires a floppy disk

for the driver installation. To make this floppy disk, copy

the contents of the Floppy folder, found on the driver CD,

onto a blank floppy disk then follow the directions below.

For A New Installation

Important: During NT installation you will be asked to

restart several times. If during any restart the RAID BIOS

reports an incomplete Mirror set, disregard the message,

continue with the installation, and let the Mirror rebuild

on its own. This should happen only once and it's done

automatically. Please do not interfere with this process.

1. Setup the RAID array prior to NT installation.

2. Follow Microsoft's NT installation procedure.

3. When booting from Microsoft Windows NT 4.0 CD,

the following screens will appear.

4. Screen 1, Setup is inspecting your computer's

hardware configuration, press F6 key to specify

and add the driver.

5. Screen 2, Windows NT Setup, Setup is loading

files, keep pressing F6 key to add driver.

6. Screen 3, if screen 3 does not appear for options to

Specify Additional Device then shut off system and

repeat steps 4-5 otherwise continue to step 7.

7. Insert the driver diskette and press S.

8. Screen 4, Windows NT Setup, highlight Other and

hit Enter.

9. Screen 5, Windows NT Setup, make sure driver

diskette is in floppy drive and press Enter.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Sin comentarios

SIIG Serial ATA PCI Guía de instalación Pagina 12