SIIG Serial ATA PCI Guía de instalación descargar pdf (Pagina 15)

8. Press Enter to finish driver installation, then follow

the on-screen instructions to complete Windows

2000 installation.

When Windows installation completes, go to SATARaid

GUI on page 18 and install the RAID monitoring utility.

For An Existing Installation

1. Setup the RAID array prior to driver installation and

boot up to Windows.

2. At the Found New Hardware Wizard, click Next.

3. Select Search for a suitable driver for my device

(recommended), then click Next.

4. Insert the driver CD, check CD-ROM drives, uncheck

the other check boxes, click Next, click Next again.

5. Click Finish. Remove the driver CD, then restart

Windows to complete the installation.

When Windows resumes, go to SATARaid GUI on page

18 and install the RAID monitoring utility.

Windows XP/Server 2003

A new installation of Windows XP and Server 2003

requires a floppy disk for the driver installation. To

make this floppy disk, copy the contents of the Floppy

folder, found on the driver CD, onto a blank floppy disk

then follow the directions below.

For A New Installation

Important: During Windows installation you will be

asked to restart several times. If during any restart the

RAID BIOS reports an incomplete RAID set, disregard

the message, continue with the installation, and let the

Mirror rebuild on its own. This should happen only once

and it's done automatically. Please do not interfere with

this process by re-configuring the RAID sets.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Sin comentarios

SIIG Serial ATA PCI Guía de instalación Pagina 15