SIIG Serial ATA PCI Guía de instalación descargar pdf (Pagina 14)

2. Highlight Silicon Image Sil 3112 SATARaid

Controller and click Properties. A message This

device is working properly is displayed in the dialog

box, the driver has been correctly installed.

Windows 2000

A new installation of Windows 2000 requires a floppy

disk for the driver installation. To make this floppy disk,

copy the contents of the Floppy folder, found on the

driver CD, onto a blank floppy disk then follow the

directions below.

For A New Installation

Important: During Windows 2000 installation you will

be asked to restart several times. If during any restart the

RAID BIOS reports an incomplete RAID set, disregard

the message, continue with the installation, and let the

Mirror rebuild on its own. This shouldhappen only once

and it's done automatically. Please do not interfere this

process by re-configuring the RAID sets.

1. Setup the RAID array prior to Windows installation.

2. Follow Microsoft's Windows 2000 installation

procedure.

3. Restart the computer when prompted by the

installation.

4. At the Windows 2000 Setup screen, press F6.

5. When prompted press S to specify the location of

the driver.

6. Insert the driver diskette, then press Enter.

7. Select Silicon Image Sil 3x12 SATARaid Controller

for Windows NT 4.0 and 2000, then press Enter.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Sin comentarios

SIIG Serial ATA PCI Guía de instalación Pagina 14