SIIG Serial ATA PCI Guía de instalación descargar pdf (Pagina 13)

10. Screen 6, Windows NT Setup, highlight Silicon

Image Sil 3x12 SATARaid Controller for Windows

NT 4.0 and 2000 and hit Enter to load driver.

11. Screen 7, Windows NT Setup, the RAID driver,

Silicon Image Sil 3x12 SATARaid Controller for

Windows NT 4.0 and 2000 should be listed. Hit

Enter. Setup will load the RAID driver.

12. Follow on-screen instructions to complete setup

for your NT version.

When Windows installation completes, go to SATARaid

GUI on page 18 and install the RAID monitoring utility.

For An Existing Installation

1. Setup the RAID array prior to driver installation

and boot up to Windows NT.

2. Click Start, Settings, Control Panel. Double click

SCSI Adapters icon, then click the Drivers tab.

3. Click Add…, then Have Disk....

4. Insert the driver CD, type in D:, then click OK.

(Change D: to match your CD-ROM drive letter)

5. Select Silicon Image under Manufacturers, under

SCSI Adapters select Silicon Image Sil 3112

SATARaid Controller, then click OK.

6. Remove the driver CD, close all open Windows,

then restart NT to complete the driver installation.

When Windows resumes, go to SATARaid GUI on page

18 and install the RAID monitoring utility.

To Verify Windows NT 4.0 Installation

1. Click Start, Settings, Control Panel. Double click

SCSI Adapters.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Sin comentarios

SIIG Serial ATA PCI Guía de instalación Pagina 13