SIIG Serial ATA PCI Guía de instalación descargar pdf (Pagina 18)

SATARaid GUI

The SATARaid GUI provides the user an easy way to

monitor your RAID set. It also offers administrative tools

to save, copy, or send via E-mail the current configuration.

Installing SATARaid GUI

1. Place the driver CD into the CD-ROM drive.

2. At the Windows desktop click Start, then Run.

3. Type D:\Setup.exe, then click OK. (Change D: to

match your CD-ROM drive letter)

4. Follow the on-screen instructions to complete the

installation.

Note: Before installing the SATARaid GUI in

Windows NT 4.0, make sure Service Pack 6 (SP6) or

greater is installed.

Using SATARaid GUI

During the installation process, the SATARaid GUI was

saved in the Windows Startup folder, a small blue

SATARaid logo will appear in the right-hand corner of

taskbar. To launch the GUI, simply click on the icon.

Upon launching the GUI, the the first window which

identifies the computer running SATARaid should appear

similar to the following.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Sin comentarios

SIIG Serial ATA PCI Guía de instalación Pagina 18