SIIG Serial ATA PCI RAID Manual de usuario descargar pdf (Pagina 10)

Introduction

1-3

1-2 Introducing the

UltraATA100 PCI RAID

The UltraATA100 PCI RAID is an ultra high-speed dual channel

UltraATA100 RAID controller board for use in Pentium-class

computers. With full support specified in ATA/ATAPI-5, it

achieves burst data transfer rates up to 100MB/sec and supports

drive capacities up to 128GB. And it also provides full backward

support for UltraATA 66/33, EIDE/Fast ATA-2, IDE hard drives.

PCI Plug-n-Play makes the installation quick and easy, the en-

hanced BIOS auto-detects device types and fine tunes to the best

performance for each connected IDE/ATAPI hard drive.

1-2.1 Key Features and Benefits

• PCI Plug-n-play 2.1 compliant

• 2 independent IDE/ATA channels, supports up to four IDE/

ATA hard drives and 128 Bytes buffer

• Supports RAID 0 (striping), RAID 1 (mirroring) and RAID

0+1 (mirror+striping)

• CRC (Cyclical Redundancy Check)

• Built in 80-pin cable detect circuitry

• Supports External BIOS

• Co-exists with onboard IDE controller

• 32-bit 33 MHz PCI Interface

• Supports bus master DMA at 133 MB/sec PCI burst rate

• Supports maximum IDE/ATA data transfer rate of 100 MB/

sec

• Compatible with Microsoft IDE/ATA drivers (Windows 98/

98SE/Me/Windows NT 4.0 and Windows 2000)

• 3.3V Operating Voltage with 5V tolerant I/O

1-2.2 System Requirements

• Pentium-class computer with one available PCI slot

• Windows 98/98SE/Me/2000 and NT4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

Sin comentarios

SIIG Serial ATA PCI RAID Manual de usuario Pagina 10