SIIG Serial ATA PCI RAID Manual de usuario descargar pdf (Pagina 22)

RAID

2-11

2-3.2 RAID 1 (mirroring)

Use this section to mirror New/Blank hard drives.

1. As the BIOS boots press F3 when prompted to enter

the UltraATA 100 RAID BIOS utility.

2. At the next screen press F2 to form a RAID set.

3. Press F2 to create RAID 1. In a Mirrored RAID Set the

source drive needs to be equal to or smaller than the

destination drive. For optimal performance the source

drive and destination drive should be on separate IDE

channels.

4. Answer N to Auto Setup.

5. Assign the Source drive, then assign the Destination

drive.

6. Answer N when asked to Copy from Source to

Destination.

7. Answer Y to Enable Auto-Rebuild.

8. When asked Are you Sure?, press Y to accept .

9. Press ESC to exit the UltraATA 100 BIOS and boot

the computer.

10. Continue with Fdisk and Format steps as if you were

installing a conventional hard drive.

2-3.3 RAID 1 (mirroring)

Use this section to mirror an existing Windows installation

or data hard drive.

1. Connect the two hard drives. Follow each hard drive

manufacturers recommended jumper settings. Start

the computer.

2. Press F3 when prompted to enter the RAID BIOS

utility.

3. Press F2 to enter the RAID setup screen.

4. Press F2 to form Raid set 1 (mirror).

5. Answer N to Automatic setup .

6. Assign the Source drive, then assign the Destination

drive.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

Sin comentarios

SIIG Serial ATA PCI RAID Manual de usuario Pagina 22