SIIG Serial ATA PCI RAID Manual de usuario descargar pdf (Pagina 33)

User's Manual

3-6

3. Highlight CMD PCI-0649 Ultra 100 IDE RAID Controller and

click Properties. A message This device is working properly is

displayed in the dialog box, the driver has been correctly

installed. If any error message is displayed, remove CMD PCI-

0649 Ultra 100 IDE RAID Controller listing, restart Windows

and reinstall the drivers.

3-3.4 Windows NT4.0 Driver Installation

For a new Windows NT installation

1. Setup the RAID array prior to the NT installation.

2. Follow Microsoft's NT installation procedure.

3. When the system is booting from Microsoft NT4.0 CD, the

user will see the following screens.

4. Screen 1, Setup is inspecting your computer's hardware

configuration, press F6 key in order to specify and add the

UltraATA 100 NT4.0 driver.

5. Screen 2, Windows NT Setup, Setup is loading files, keep

pressing F6 key to add the UltraATA 100 NT4.0 driver.

6. If screen 3 does not appear for options to Specify Additional

Device then shut off system and repeat steps 4-5 otherwise

continue to step 7.

7. Insert the Software Installation diskette and press S.

8. Screen 4, Windows NT Setup, highlight Other and hit

Enter.

9. Screen 5, Windows NT Setup, make sure Software Installation

diskette is in floppy drive and press Enter.

10. Screen 6, Windows NT Setup, highlight CMD PCI-0649

Ultra 100 IDE RAID Controller and hit Enter to load the

UltraATA 100 RAID driver.

11. Screen 7, Windows NT Setup, the UltraATA 100 driver,

CMD PCI-0649 Ultra 100 IDE RAID Controller should be

listed. Hit Enter. Setup will load drivers.

12. Follow onscreen instructions to complete setup for your NT

version.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 53 54

Sin comentarios

SIIG Serial ATA PCI RAID Manual de usuario Pagina 33