SIIG Serial ATA PCI RAID Manual de usuario descargar pdf (Pagina 27)

User's Manual

2-16

2-9 Rebuilding a Failed Mirrored-Striped set

The steps below will guide you in rebuilding a failed Mirrored-

Stripe set. When a failure to one drive occurs you will be notified

either by the RAID BIOS utility during boot or by the Medley GUI

while in Windows. In the following steps you will replace the bad

drive with a new drive , enter the RAID BIOS, configure the new

drive as Spare then reboot the system. The RAID bios will change

the Spare drive designation into a member of the Mirrored-Striped

set.

1. Replace the failed drive with one of identical size or of

larger capacity.

Note: It is recommended to replace the bad drive with an

identical drive, or with a drive of the same make. In all

cases, the replacement drive must be of equal or larger

capacity than the bad drive.

2. Start the computer and during boot press F3, when

prompted, to enter the RAID BIOS.

3. Press F3 to assign a Spare drive.

4. Press the number corresponding to the new drive.

5. When asked Are You Sure? Press Y to accept.

6. Press ESC to exit the RAID BIOS utility and reboot the

computer.

Note: Ignore the error message displayed by the RAID BIOS

and continue booting. The mirror will rebuild automatically.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 53 54

Sin comentarios

SIIG Serial ATA PCI RAID Manual de usuario Pagina 27